Braided shunts / connections with insulation


We provide the braided shunts with different types of insulations. To our standart range belongs the following different insulations:

HT105 / PVC

Used forround and flat connections
Operating voltage1000V AC – 1500V DC
Operating temperaturemax. 105°C
Self-extinguishingUL 94 VO
Dielectric strength20 kV/mm
colorblack, or transparent at request
noticeThis is the same type on insulation which will be used at laminated copper bars

RHO / Silikon

Low toxic fumes, opaque and self-extinguishing in accordance with FS304142 specification

Used forround and flat connections
Operating voltage1000V AC – 1500V DC
Operating temperaturemax. 250°C
Dielectric strength21 kV/mm
Reaction to fire (CSE)class 1
Smoke class determinationF1
colorblack and grey
noticeThis insulation is extremely flexible and temperature-resistant.

ST / shrink tube

Used forround and flat connections
Operating voltage600V
Operating temperaturemax. 125°C
Dielectric strength2500V
Reaction to fire (CSE)UL224
colorblack, yellow green or other colors at request

Other types of insulation like rubber-tube, fiber-glass or shrink tube with inside glue are available too.

Braided shunts / connections without insulation

The contact area of this braided shunts will be pressed with high pressure into solderless seamless Cu Tube. The braided tapes and the tubes are of same analysis and conductivity. No additives are used at the process of pressing the contact areas. During this process the braid and the tube will be extremely squeeze ramming and provide very junction values. This packing protects the item for environmental impact too.

We could produce the terminal in different shapes for the same cross section. Extreme flat and more width or very compact because of this production method. Also, the length of the terminal is customizable.

The braid is available in different diameter of the single wire. We offer you the following solutions: Ø 0,07 / 0,10 / 0,15 / 0,20mm. Beside the different sizes of the single wire we provide a multitude of cross sections starting from 2,5² up to 4500².

Design of a typical flexible copper connector is round or flat, with contact area and drilling at both ends. We could produce also variations of this. Examples for this could be multilayer over or beside each other. Contact areas with 90° turned position, different sizes of the contact area or hole pattern.

Some instance of this you see in the sketches below.

Different hole pattern diameter of the holes and positions are possible. We provide red copper, tinned copper, aluminum and stainless steel for the braid and the tubes. We produce the items which you find in our catalogue, variations of this, (different length, width, dimension of the contact area) and complete customized braided shunts according your drawing.

If you don’t have a drawing you could use our request form. Please fill in the values you have and send us the blank. We check this and send you an offer.

You could find the schedule here in the download area below.

Downloads – Braided shunts